User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699

5.1 Create a new template file

In order to create a new template…

• Read a tag (any tag, the tag read will determine which folder tabs are displayed)

• Select the Factory/Agency folder tab.

Example: IAG tag template…

Example: Type 2 LCD tag template…

• If required, use the selection boxes to set up the Factory/Agency tag programming template data.

Initially, the "Not Changed"

status indicates that the

template will not modify the

corresponding field in the

tag when it is programmed.

To make a change, view the

selections by clicking on the

down arrow

⎬ on the right

hand side of each field one

at a time and select the

appropriate values for the

specific tag.

If you change any of the

fields the "Not Changed"

status will be replaced by

the selected value.

Note: The Vehicle Reference

field value (shown as "200" in

the IAG tag example and "72"

in the Type 2 LCD example)

represents the cumulative total

of the first 4 field values

assigned as "vehicle" data.

Note: If the Supervisor

changes any field then a

message "(Modified. Should

save template before

programming tag)" appears on

the bottom line to the right of

"Template File:" in either

screen. The Supervisor must

save the modified template file

and give it a new name.

Note: A template file name is

not displayed when there is no

template loaded.