User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699

4.5.3 Program a Type 2 LCD tag

• Load and verify the required "template" file for programming the tag. Refer to the section titled Load a

Type 2 LCD Template.

• Place the tag to be programmed into the foam insert in AU drawer

. Close the AU drawer.

• If the Supervisor has set the Automatic Write function (see Supervisor Configuration of Automation

parameters), the tag will be programmed. Within 1 second the "Write Successful" message is displayed (as

shown further below).

• If the Automatic Write function has not been set, click on the Program button.

• Within 1 second the "Write Successful" message is displayed.

Message "Write Failed"

The following message appears whenever the tag cannot be programmed.

The cutout foam "cradle" along with optional foam inserts allows for several different tag configurations to be used. The tag orientation

is shown in a specific photo appendix to this document, example: Type 2 LCD tag orientation in the AU drawer. More photos of the

AU drawer depicting various tag orientations along with different foam inserts will be added as the TPS system is expanded to handle

other tags.

Click on "Details" to view more report data.

n exam

le of more data is shown at ri

ht.

Reason for failure

Unless the Write

Successful message is

displayed first, then

before opening the

drawer you must wait

for antenna unit green

light to come on.

It is not necessary to

wait for the tag "beeps"

to stop before opening

the drawer.