User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699
©1999-2008 MARK IV INDUSTRIES CORP. I.V.H.S. DIVISION pg. 32 of 69
To display the value read in the scratch pad data fields, click on the Scratch Pad folder tab.
To display the value read in the LCD data fields, click on the LCD folder tab.
To display the value read in the interactive scratch pad 4-bit data field
4
, click on the Scratch Pad (Custom)
folder tab.
4
These 4 bits comprise the data field for "Agency data 2" in the R/W partitioned area of the tag.
The selection boxes shown
here display selected values
only if a Supervisor created
and saved a new template.
Refer to the section "Create a
new Template file".
There would be selection boxes
shown here only if a Supervisor
created and saved a new template.
Refer to the section "Create a new
Template file".
1. Clears all toll collection data to zero
only if the "Clear Toll Collection
Data" default value "selected" is set
and
in the LCD tab the "Balance" is
set to "not changed" (as shown
below).
2. Clears all toll collection data to zero
except Plaza ID (= 177), TC date (=
PC date) and TC time (= PC time) if
in the LCD tab the "Balance" is set
to "clear" or "specific".
"Clear Unassigned Bits", when selected, will set all the unused bits in the entire field to zero.
Note 1. If a template file is not loaded then the "Clear Unassigned Bits" default value is
"selected".
Note 2. If a template file is loaded then this "Clear Unassigned Bits" value is set to the data that
was stored in that template file.
Similar to "Clear Unassigned Bits",
explanation below, except…
If a template file is not loaded then
the "Clear Traffic Management Data"
default value is "selected".