User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699

To display the value read in the scratch pad data fields, click on the Scratch Pad folder tab

To display the value read in the interactive scratch pad 30 bit data field, click on the Scratch Pad (Custom)

folder tab.

There would be more selection

boxes shown here only if a

Supervisor created and saved an

IAG template.

Refer to the section "Create a new

IAG Tem

late file".

"Clear <specified>

Data", when selected,

will set all the bits in the

<specified> set of fields

to zero.

"Clear Unassigned Bits", when selected, will set all the unused bits in the entire field to zero.

Note 1. If a template file is not loaded then the "Clear Unassigned Bits" default value is

"selected".

Note 2. If a template file is loaded then this "Clear Unassigned Bits" value is set to the data that

was stored in that template file.

Similar to "Clear Unassigned Bits",

explanation below, except…

If a template file is not loaded then

the "Clear Traffic Management

Data" or "Clear Toll Collection

Data" default value is "selected".

OIMPORTANT !O

Be aware of these values if the

AUTO WRITE function is enabled

and there is no template file

loaded.