Use and Care Manual

ASSEMBLY INSTRUCTIONS
1. Check that the control knob for the gas
supply system is turned to the “OFF” position
before starting any assembly.
2.Turn the cylinder valve on the tank clockwise to
close the propane tank.
Attach the preassembled regulator from the body
to the cylinder valve by turning the regulator
coupling nut clockwise. Make sure it is fastened
securely and tighten connections by hand only.
3.Remove the rubber cap on the electronic
igniter by unscrewing and slide battery (Not
includding) into the battery slot. Make sure the
positive side of the
battery faces outwards. Screw the electronic
igniter cap over the battery tightly.
DANGER AND WARNINGS
Propane tank must be a minimum of 60 inches away at all times.
4