User Manual

Racing Electronics SWITCH Manual Version 2.0 11/05/2017
Racing Electronics ‘’Switch’’ Operation
OPERATION MODE (Default mode when you power ON)
Audio In Audio In. Used to connect a Radio device, Cell phone or Music player. The volume level for that input is
controlled by the connected device only. This audio input is always attenuated whenever a signal is present
on Preset Channel 1 or 2. Accepts mono or stereo 1/8’’ jack.
Audio Out Audio Out. Used to connect headphones or earbuds. Accepts 1/8’’ mono or stereo jack.
Power ON-OFF. Hold for 2 Seconds to power ON-OFF.
Preset Channel 1. Press to select Preset Channel 1. This Channel is always the default at power ON.
Its as shipped value is NASCAR Officials frequency of 454.0000 Mhz.
Preset Channel 2. Press to select Preset 2.
SCAN, Press to SCAN between Preset 1 and 2. Once a conversation on one of the Preset is active, it
must terminate before the scanning process resumes. (Not Available on SWITCH RACER)
SCAN Priority 1, Hold and press to start SCAN with Priority on Preset 1. If Preset 1 becomes
active, it will interrupt Preset 2. (Not Available on SWITCH RACER)
SCAN Priority 2, Hold and press to start SCAN with Priority on Preset 2. If Preset 2 becomes
active, it will interrupt Preset 1. (Not Available on SWITCH RACER)
Volume UP. Press to increase volume of Preset 1 or 2.
Volume Down. Press to decrease volume of Preset 1 or 2.
Long
Press
PROGRAMMING. Hold for 2 seconds to enter programming mode. Details are provided below, in the
Programming Sections.
Long
Press
Hold for 2 seconds to display Preset 1 sub channel information.
Long
Press
Hold for 2 seconds to display Preset 2 sub channel information.
PROGRAMMING (Basic)
Long
Press
PROGRAMMING Mode access. Hold for 2 seconds to enter programming mode.
1. Press or hold or key to select the desired channel or frequency.
2. Press twice to exit programming mode and monitor the new channel.
3. Press or to exit Programming mode without storing the new frequency and
return to selected Preset.
4. Long Press or store the new frequency as Preset 1 or 2.
PROGRAMMING (Advanced)
Long
Press
PROGRAMMING MODE access. Hold for 2 seconds to enter programming mode.
1. Press or hold or to select the desired channel or frequency.
2. Press to access sub Channel programming.
3. Press or hold or key to select the desired sub channel number.
4. Press to exit programming mode and monitor the new channel.
5. Press or to exit Programming mode without storing the new frequency and return
to selected Preset.
6. Long Press or to store the frequency and its sub channel as Preset 1 or 2 and exit
programming mode.