Datasheet

CONNECTING TO A TARGET
10-way connector
Connect the programmer to the target system using the short
ribbon cable. The programmer has a 10-way connector with the following
properties.
• Target Layout – not
end of lead view
• Header is 0.1” (2.54mm)
box header in 5 x 2
format, with polarising
notch
• GND* These pins must
be connected to target
ground
• GND One or both must
be connected to
Target ground
• VDD must be connected to target circuit Vdd
• PGM pin is only connected for LVP programming
6-way connector
The programmer is supplied with a 10-way to 6-way flying lead adapter.
Only 5 of these connections need to be made for HVP programming, as
PGM pin is only used for LVP programming. Connect the adapter to the
programmer as shown in the diagram
Clock - PGC
9
7
5
3
1
10
8
6
4
2
Data - PGD
MCLR/Vpp
PGM
N/C VDD
GND
GND
GND *
GND *
6-Way
Adapter
GND
Vpp
PGM
CLK
VDD
Data
ERROR
Program