Datasheet

incomplete information could fail this test. See section on Error
Codes.
2. Verify Configuration Bytes. Allows configuration byte
programming to be verified. See section on Error Codes.
3. Program User ID. User ID bytes are programmed – PIC18F only.
The User ID bytes must be included in the Hex file or all locations
will be programmed with 0xFF. See section on PIC18F Hex File
formats for more detail
4. Preserve Data Memory. Existing contents of device Data
EEPROM are preserved.
• 3.3VDD Voltage Output: For LF devices or circuits where 5V could
cause damage. 3.3V is default for PIC18FxxJ devices
Programmer Setup
If the Programmer is empty, a message will state this, otherwise the
current settings are displayed in the top pane.
• Program Count: The number of successful program operations
allowed can be set. If this is not checked, the default value is 65,535
• Error Flash Repeat No: The green success code or red error codes
will repeat this number of times.
• Enter a description for the Program, max 28 characters – the filename
and device name are stored automatically
• The final step is to click the Program button to load the handheld
programmer.
Once the programmer is loaded, the program description will be updated.
Read Button
If you connect a different programmer, then click Read button to update
the programmer settings pane.
You Programmer is now loaded and ready for use.
If you get errors with connecting to the programmer, see the
troubleshooting section at the end of this guide.