Datasheet

The Right-hand side of the screen shows the Programmer settings, and the Left-
hand side shows details about the PIC device, filename, programming method and
areas to be programmed or verified.
Program setup
• Select the file to use in the filename box.
Notes:
The programmer expects a Microchip type hex file (as produced by
MPLAB). The file should contain
• Program Code
• EEPROM data – if PIC device has EEPROM and data is required
• Configuration Bytes including Security information
• User ID if required
See section on Hex File formats for more details
• Now select the device family required (16F or 18F) and the device
type
• Choose the Programming Mode, Low voltage (LVP) or High Voltage
(HVP). If you choose LVP, you must connect LVP pin – see section on
Low Voltage Programming.
Note: Not all PIC devices have LVP mode – check device datasheet
• There are also four check boxes.
1. Match Device ID. Checking this box means the programmer will
read the device ID and compare it with the ID of the selected
device to ensure they match. Some newer device where there is