Datasheet

Programming Errors – Constant RED LED
This means a low battery or that the over-current circuit has tripped
1) Check battery or power supply to programmer is ok
2) Isolate circuitry (with a Schottky diode – see diagram on page 4)
that is drawing too much current, as the programmer is limited
to 150mA
Error codes – LED turns red:
2 flashes - General verify error
3 flashes - Data memory did not verify
4 flashes - Code memory did not verify
5 flashes - User ID words did not verify *
6 flashes - Configuration Bytes did not verify *
7 flashes - Device ID did not match *
8 Flashes - Set Program count reached *
Constant Red LED – Low battery or Over-current trip > 150MA
FURTHER INFORMATION
Please contact [e-mail] for technical support or go to our website
support pages for latest software.
See www.kanda.com/support > Software Downloads
Contact details
Website: www.kanda.com
email: [e-mail]
Phone/Fax: [phone]
PICmicro, Microchip, ICSP are registered trade marks or trade marks of Microchip Corp, Az, USA