Datasheet

• 2.1mm barrel connector (coaxial plug), centre positive.
• 9V DC regulated
• 300 mA plus
A universal PSU or Wall Transformer is available on the Kanda shop –
Order Code PSU9V-UNI
TROUBLESHOOTING
Windows driver problems
If you get a driver error, make sure that you have run the install
software on CD and then plugged in programmer, NOT the other way
round.
The driver should appear as a "USB Serial Converter" in USB section of
Device Manager. Windows should do this automatically. If it does not,
please follow this procedure.
• Plugin Programmer and ideally remove other USB devices
• Go to Control Panel > System > Hardware screen
• Click on Device Manager button
• Open USB section and select “USB Serial Converter”
• Right click on it, and select Update Driver
• Driver location is (default install path)
C:\Program Files\embres\PICBKFUSB\driver\driver
Error Message: “Programmer not Detected”
1) Check dongle is attached to USB port
2) Check that programmer is connected to PC as shown on Page 1
3) Check battery or power supply to the programmer
4) Make sure you have a Handheld Programmer dongle, not a
standard AVRISP-U/STK200 dongle. The unit will say “Dongle” on
it.
Programming Errors – RED Flashes on LED when programming
1) Ensure your target circuit is wired correctly as discussed in the
ICSP Circuit Requirements section.
2) Check you have correct device selected, especially if ID match is
turned on
3) Ensure you have selected LVP or HVP as appropriate
4) Check programmer is powering target PIC with 5V on VDD pin
and 12V+ on VPP pin for HVP or 5V on PGM pin for LVP, during
programming
5) Check lead connections on programming header are correct