Datasheet

SIX WAY ADAPTERS
Because of the need to connect more than 1 GND pin, the adapter should connect
GND pins together. So, the adapter is not as straight forward as it first appears.
Adapters from the 10-way DIL interface to 6-way flying leads, 6-way DIL (3 x 2 0.1”
pin header), and 6-way Micromatch connectors are available from Kanda.
Order Codes are:
USING STK200 AND 300 with HAND HELD PROGRAMMER
1) STK200’s and STK300’s have two supply rails. Vcc and +5V. Vcc is the supply
to the AVR microcontroller, while pin2 of the ISP connection is connected to the
+5V rail. A result of this, is that the programmer can not be used to power these
boards during programming. They must be powered independently.
2) The original design of the STK300 reset circuit does not comply with the
requirements of the programmer. To allow programming of older STK300’s, a small
modification to the STK300 is required.
10FLEX6
10DIL6 10MICR6