User Manual

flowIQ® 2102
Installation guide
Optional customer label, e.g. water company logo (15x38 mm)
Optical eye for reading and configuration
Graphic flow indicator
Type number
(includes information on meter
Serial no. and prod. year
Configuration
(with information on display resolution
Accuracy class 2 according to OIML R49
Environment class: Electrical E2 and Mechanical M1
Environment class B and C according to OIML R49
Bar code with serial number
Expiry year of battery
Temperature class according to OIML R 49
Meter size Q3
Software version and dynamic range
Pressure stage and protection class
FCC identification
ALWAYS use new gaskets (PE
or EPDM).
The coupling’s sealing
surface must be clean
and even.
The piping must be parallel and match the meter.
If you have a smart phone you can enter this QR code to enter
www.kamstrup.com
Torque
If a pipe installation is skew to the effect that the prescribed
tightening torques would be exceeded, a telescopic coup-ling
ought to be installed.
¾” Max. 15 Nm
1” Max. 30 Nm
¾”: Max. 15 Nm
1”: Max. 30 Nm
DRAFT-5512XXXX_A1_CL-GB_06.2015
FCC ID: OUY-FLOW2102
flowIQ® 2102
FCC Cautions
Caution: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure compliance statement: This device may be used
with no restrictions, since the source-based time-averaged
output power is ≤ 60/f(GHz) mW.