User's Manual

5.Long press and hold on the rear panel on the "Reset" button more than 4 seconds after release, wait 3 seconds, at this time the blue state light
flashes quickly, the device into the distribution network state, in the device distribution network state, click on the App "light is flashing fast" button to
start the distribution network;
6.Wait for the network connection successfully, after the connection is successful, the app will pop up the interface of the connection success;
1. In this interface click "Start to use" to enter the device list interface, at which point red light is long, representing the titration pump has been
connected to the cloud, the user has also completed the binding to the titration pump.
Tips
a. Configure the device to connect to Wi-Fi only once, afte r the configuration is successful, as long as the app can be connected to the
network, open the app after the device list can be found in the device .
b. If the device configuration fails to connect to Wi-Fi, start ove r from the first step.
4.2 Binding titration pump
There are two ways for a user to bind a titration pump.
The first way is to bind the titration pump by the above redistribution network;
The second way is that the titration pump has been connected to the cloud through the wireless router, at this time the phone can be connected to the
wireless router, the app will display the local available titration pump, users can scan the local available equipment out of the titration pump list, click on
the corresponding titration pump, binding, the specific operation is as follows:
1-2.Open the app, click the "" button in the upper right corner of the device to add the device, enter the add device interface, select the titration
pump to bind in the list of locally available devices, and click into;