User's Manual

Kamoer fluid tech(Shanghai)Co., Ltd. UIP WIFI User Manual
9
2.1 Continuous mode
After booting up, select “Continuous Mode” in the navigation bar to enter the continuous
mode control interface; in continuous mode, after clicking Start, the pump will run continuously
until the stop button is clicked;
Figure 2-2-1 Continuous mode interface
a, Continuous mode: continuous mode title;
b. Tube type: continuous mode tube type setting, tube type record has corresponding flow rate
information, the same speed will use different tube type flow rate will be different;
c. Speed: the current set speed of the continuous mode, the speed cannot be directly set, and the
speed is converted according to the current flow rate setting;
d, Temperature: display the temperature of the external temperature sensor, when the external
sensor is not connected, it is displayed here;
e, Flow rate display: display the current set flow rate, can be modified by the on-screen keyboard
or flow rate plus / minus buttons;
f. Acceleration/deceleration button: Click this button to increase or decrease the flow rate. The
amount of increase or decrease each time is the amount of change indicated in i; the button
operates when the motor is running and stopped;
g、Set button: Click to enter the continuous mode setting interface. For details, see 2.2.1
Continuous mode setting;
h, direction button: click to switch the direction of rotation of the pump, set when the pump stops
running, can not operate when the pump is running;
i, acceleration and deceleration granularity: used to modify the speed of the click
acceleration/deceleration button change, there are several sizes of 0.1, 1, 5, 10;
j. Runn Volume (ml): The volume in which the continuous mode has been run. When the pump is
running, the run volume continues to increase. When the continuous mode is restarted, the run
volume increases from 0;
k, Start/Stop button: continuous mode start stop button;