User's Manual

Kamoer fluid tech(Shanghai)Co., Ltd. UIP WIFI User Manual
10
l, Wi-Fi status display: Here shows the status of Wi-Fi, the specific Wi-Fi status refers to 3.2
ration network chapter;
2.2.1 Continuous mode setting
In the continuous mode, click the "Settings" button in the lower left corner to enter the continuous
mode setting interface:
Figure 2-2-1-1 Continuous mode setting interface
a. Tube type setting: Click to enter the tube type selection interface and select the corresponding
tube type. Each tube type has a corresponding relationship between the speed and the flow rate. If
not, the tube type can be performed in the system setting->tube type. calibration;
b. Liquid level detection: Click the liquid level detection to enter the liquid level detection setting
interface, set the liquid level detection on and off in the liquid level detection setting interface, the
type of alarm; if the liquid level detection is on, when the pump works, if When the liquid level
alarm is detected, the pump stops working and an alarm is given;
c. Foot switch: Click to switch the opening and closing of the foot switch control. If the foot
switch is turned on, the continuous mode can be controlled to start and stop by the foot switch;