Operation Manual
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8 TKG MX 5 I - 080114
Assembly page 8/32
Fax +32 2 359 95 50
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
WALL-MOUNTING BRACKET
To make the storage easier, your appliance is delivered with a wall-mounting bracket that you
can fix directly onto the wall thanks to the screws and raw plugs provided. Therefore measure
the space between both notches on the backside of the mount and then make a hole in the
wall at the desired height and slide the raw plugs. Place the mount facing the holes, the screws
in the raw plugs and screw until there is the least possible play between the screw heads and
the mount.
HOW TO USE
Your new stick mixer is a convenient and easy to use for powerful high speed blending. It is
great for shakes, soups, sauces, omelettes and much, much more.
Before using for the first time, the appliance should be cleaned with a damp cloth. Ensure
the unit is unplugged first!
Screw the shaft onto the screw thread at the bottom of the motor unit. Take care to screw
the shaft in the direction shown by the locked symbol. Just using gentle hand pressure
ensures that the shaft is fully tightened onto the motor unit.
Put the ingredients into a suitable container such as a mixing bowl, cooking pan or mixing
beaker (if included). Do not overfill to avoid splashing when the motor is switched on.
Plug in at the mains.
Put the shaft of the appliance into the ingredients before pressing a switch. This will avoid
splashing when the motor is switched on.
You can choose between 2 speed settings: press switch I to blend at normal speed or
switch II to blend at maximum speed.
Remember to use for no longer than 1 minute continuous use. The motor must then be
rested for 10 minutes.
HOW TO CLEAN THE DETACHABLE SHAFT
Always unplug the unit before cleaning.
The motor unit should only be wiped down with a moist cloth.
Unscrew the shaft from the screw thread at the bottom of the motor unit. Take care to
screw the shaft in the direction shown by the unlocked symbol .
Wash the shaft under running water immediately after use. If it is very dirty, it can be
washed in warm washing-up water.
DO NOT WASH THE METAL DETACHABLE SHAFT IN A DISHWASHER. The chemicals used in
dishwashers will mark and stain the surface of the metal leg.
For best results after cleaning and drying, lightly coat the metal surfaces with cooking oil.
This will keep the finish bright and stain free.
Dry the detachable shaft thoroughly after washing.
NEVER IMMERSE THE MOTOR UNIT IN ANY LIQUID.