Operation Manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must reproduced and folded in order to obtain a mini
booklet A5 (+/- 150 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don’t change the page numbering. Keep the language
integrity.
8 KA EL 18-7/9/11 - 070509
Assembly page 8/24
Fax [phone]

 When scrapping the appliance, all regulations concerning the disposal of oil should be
followed.
(*)
Competent qualified electrician : after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
CONNECTION TO THE MAINS SUPPLY
The radiator should only be connected to an earthed socket installed in accordance with the
regulations.
Make sure that the supply voltage corresponds with the voltage marked on the rating label
(230V (AC)) and the rated electric current is not lower than 10A.
This product complies with all binding CE- labelling directives.
ASSEMBLY
Before using the radiator for the first time, the wheels must be fitted to the unit and then
secured with the wing nuts provided.
 Turn the heater upside down.
 Position the two wheels base between the end fins.
 Attach them to the heater using the U-hook and wing nuts.
 Fasten the wing nuts.
 Turn the heater the right way around.
THE HEATER MUST NOT BE USED WITHOUT ITS WHEELS.
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation.
OPERATION
1. Select the power by turning the power selector. It has 3 different positions:
I = reduced power
II = medium power
III = full power
2. Turn the thermostat clockwise to increase the temperature and anticlockwise to reduce it.
The pilot light will turn on indicating that the appliance is heating. During use, the pilot light
will come on and off. It will turn off as soon as the set temperature is reached.
3. If you want to switch off your appliance, turn off the two switches (thermostat knob to
“LOW” position and power selector to “0”), remove the plug from the power supply and
place it in its storage location. CAUTION: YOUR APPLIANCE WILL REMAIN HOT FOR A FEW
MINUTES.
4. To move your appliance, take it by its handle, raise it and roll it.