Operation Manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must reproduced and folded in order to obtain a mini
booklet A5 (+/- 150 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don’t change the page numbering. Keep the language
integrity.
8 KA EL 16-7/9/11 - 070418
Assembly page 8/24
Fax [phone]

 When scrapping the appliance, all regulations concerning the disposal of oil should be
followed.
(*)
Competent qualified electrician : after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
CONNECTION TO THE MAINS SUPPLY
The radiator should only be connected to an earthed socket installed in accordance with the
regulations.
Make sure that the supply voltage corresponds with the voltage marked on the rating label
(230V (AC)) and the rated electric current is not lower than 10A.
This product complies with all binding CE- labelling directives.
START UP
Before using the radiator for the first time, the feet must be fitted to the base of the unit and
then secured with the screws provided.
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation.
USAGE
Your appliance is fitted with an air humidifier (on the opposite side of the control panel). Before
switching on your appliance, fill the water tank (with demineralized water). Do not overfill over
the HIGH level.
How to fill the tank:
- Remove the tank and its support from the heater
- Remove the tank from its support
- Open the lid and fill the tank
- Close the lid, replace the tank on its support
- Replace everything on the heater.
CAUTION: IF YOU WANT TO FILL THE TANK DURING USE PAY ATTENTION NOT TO GET BURNED
BECAUSE IT BECOMES VERY HOT.
1. There are two indicator light switches; you can adjust them on your requirement.
Switch positions
I = reduced power
II = medium power
I+II = full power
2. Turn the thermostat to position 4 and switch on your appliance (1 or 2 switches).