Operation Manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must be reproduced and folded in order to obtain a mini
booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B. Don’t change the page numbering. Keep the language
integrity.
7
Assembly page 7/18
Fax [phone]

(*)
Competent qualified service: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this service.
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13-amp power socket. If a BS1363 approved 13-amp
plug is used, it should be fitted with a 13-amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
CONNECTION TO THE MAINS SUPPLY
The radiator should only be connected to an earthed socket installed in accordance with the
regulations.
Make sure that the supply voltage corresponds with the voltage marked on the rating label
(230V (AC)) and the rated electric current is not lower than 10A.
This product complies with all binding CE labelling directives.
START UP
Before using the radiator for the first time, the feet must be fitted to the base of the unit and
then secured with the screws provided.
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation.
USAGE
1. There are two indicator light switches; you can adjust them on your requirement.
Switch positions
I = reduced power
II = medium power
I+II = full power
2. Turn the thermostat to position 4 and switch on your appliance (1 or 2 switches).
3. After 10-15 minutes, if you feel the room temperature is too low or too high, just adjust the
temperature to the desired position.