Use and Care Manual

8
www.KALORIK.com
GST 47574 - 200605
kill bacteria in the water tank. Simply fill the tank to “MAX” level with
vinegar, turn on the machine and allow it to heat up. “Steam” out
the vinegar into a kitchen sink until the level reaches “MIN”.
Remove the vinegar and rinse out with water 2-3 times, until there is
not trace of the vinegar left. Repeat the same process with distilled
water.
• When storing, place the garment steamer in a dry, dust-free
environment. Ensure that the tank is completely dry when storing to
avoid mildew.
NOTE:
‒ Do not soak in water to clean this product, otherwise it may
cause electric shock and unit to short circuit.
‒ Do not use strong alkali or strong acid to avoid damaging the
unit or causing discoloration of the unit.
‒ Please unplug the steamer and cool the main unit before
carrying out maintenance work. Failure to do so may cause
danger of electric shock or scalding.
TROUBLESHOOTING
Issue
Reason
Solution
Steamer does
not produce
steam
Water tank does not have
water
Add water to water tank
The water level is too low
Add water to water tank
(above MIN level)
The water tank is not
properly installed
Ensure water tank is
clicked into place before
steaming.
The product is not fully
heated
Let the unit heat for
about 45 seconds; when
the product indicator
light is steady, the
steamer is ready for use
The steam switch was not
fully pressed
Ensure the steam switch is
clicked into place.