Owner Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
11 FE 40764 - 120501
Assembly page 11/40
Fax [phone]
TROUBLESHOOTING
Malfunction Possible cause Solution
The device
does not
function.
No power
supplied to the
appliance
Check the power outlet.
Make sure the plug is correctly
inserted.
The lid is not
fitted correctly.
Check that the lid and all the parts
are well assembled and that the
safety switch is activated.
The device is
defective
Contact the Kalorik Customer
Service.
Low juice
quantity
Wrong fruit type Use preferably the juiciest type of
fruits.
Fruits are too old Fruits that have been freshly and
recently purchased should
guarantee an optimal juice /
nutrients / vitamin content.
Too much pulp
residue in the
sieve
Clean the sieve, using the brush
supplied and make sure the holes are
not clogged.
Loud noise Bad assembly Check that all components are
installed correctly.
Too much pulp
residue in the
sieve
Clean the sieve and remove the
excess pulp.
The appliance
is jamming, or
cannot be
disassembled
Some foods is
too bulky and
clogged the
appliance
Press the switch in “R” position for 3 to
5 seconds, repeat 2-3 times if
necessary. Remove the lid and
remove the food parts that clogged
the appliances.
Pulp ejection is
blocked
Pulp spout is
clogged.
Remove all the parts, clean the
strainer housing under running water,
removing the rubber seal underneath
and replacing it after wards. Use
narrow tip of the brush if needed.
Sieve is clogged Remove all the parts, clean the sieve
under running water, using the
narrow top of the brush if necessary
to remove any residue; make sure
the gutter and small hole at the
bottom of the sieve are free of
residue and clean.