Installation Sheet

INSTALLATION INSTRUCTIONS

Thermostatic Valve Trim

1048650-2-K

5 of 6

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.

3. INSTALL THE FRONT PLATE

Valve Stem

Adapter

7/16"

(11 mm)

MAX

Verify the seal covers the wall opening.

Nut

Screw

Stud

 Ensure the valve stem adapter is ﬁ rmly pressed onto the valve stem.

 Secure the valve stem adapter to the valve with the correct length screw, as selected in the “Install the

Valve Stem Adapter” section of this guide.

 Thread the two studs into the threaded holes of the valve.

 Place the front plate assembly over the studs.

 Thread the nuts onto the studs to secure the front plate assembly to the wall. Do not overtighten the nuts.

NOTE: If the front plate assembly does not lay ﬂ at on the wall surface, loosen the nuts and adjust the threaded

studs, then retighten the nuts. Once properly installed, the threaded studs must not protrude more than 7/16”

(11 mm) through the front plate assembly.

 Visually inspect the front plate assembly to ensure the foam seal is completely covering the wall opening. If

not, stop the installation and repair the wall opening.