Installation & Assembly

A
A
B
A
A
1284108-2-A
3 4
5 6
1
1 2
KALLISTA
1284108-2-A
7 8
IMPORTANT INFORMATION
WARNING: Risk of scalding. High water temperature
can cause severe burns. Set the water temperature at or
below 120°F (49°C) following the adjustment procedure in
the valve installation instructions.
CAUTION: Risk of scalding. KALLISTA low-fl ow
showerheads/handshowers are designed for use with
compatible KALLISTA valves. When installing a low-fl ow
product to an existing showering system, verify
compatibility before showering. Do not use this KALLISTA
low-fl ow product with a shower valve that allows the water
temperature to become too hot when other plumbing
products are used.
Prior to using your shower, verify your new showerhead/
handshower is compatible with your shower valve (located
behind the wall):
• While standing outside the shower, turn on the shower
valve. Do not step into the shower.
• Adjust the water to your typical showering temperature.
• Have someone fl ush the nearest toilet.
• With your hand, carefully check the water temperature,
from the showerhead/handshower while the toilet is
refi lling.
• If the water becomes signifi cantly more hot, you will need
to replace the shower valve with a compatible KALLISTA
valve or return your showerhead/handshower.
NOTICE: For a showerhead rate at 1.75 gal/min (6.6 l/min)
maximum, use with an automatic compensating valve rated
at 1.4 gal/min (5.3 l/min) or less.
CAUTION: Risk of product damage. To avoid plugging
the showerhead spray outlets, use thread sealant tape on the
shower arm threads. Do not use pipe dope.
Follow all local plumbing and building codes.
1A. Silicone Sealant
1B. Sealant Tape
6A. Optional: Apply a bead of clear silicone sealant around
the escutcheon.
7A. Flush the shower arm.
8A. Apply sealant tape. Tighten to the arm, using care not to
scratch the fi nish.