Installation Sheet

INSTALLATION INSTRUCTIONS
Lavatory Faucet
1223783-2-D
4 of 7
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
2. INSTALL THE HANDLES
Seal
Gasket
Washer
Valve
Assembly
Handle
Assembly
All Other Trim
P24800 Trim
DO NOT apply silicone
sealant in this groove.
Apply silicone sealant in
the shaded area only.
O-Ring
P24706 Trim
Apply silicone sealant
to the underside of escutcheon.
Install the Handle Assemblies
 Ensure that the seal gasket or O-ring is installed to the underside of the cold handle assembly.
For P24706: Apply a bead of silicone sealant to the underside of the escutcheon.
For P24800: Apply a bead of silicone sealant around the base of the handle assembly.
 Fit the valve assembly through the top of the lavatory.
 Partially thread the screws into the ring.
 Install the washer and ring onto the valve assembly. Thread the ring up the valve assembly.
 Orient the handle with the faucet.
 Tighten the screws. Do not overtighten!
 Repeat the procedure to install the hot handle assembly.