Installation & Assembly

Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALLATION INSTRUCTIONS
1072019-2-B
Page 2 of 3
P23070
Quincy™ Wall Mount Pot Filler
2. INSTALL THE FAUCET ASSEMBLY
Finished Wall
Supply
Mounting Plate
Screw
Set Screw
Anchor
Escutcheon
Shank
Spout
Small
Set Screw
Slide the mounting plate onto the faucet shank.
Align the groove in the underside of the faucet shank with the set screw hole in the mounting plate and
secure with the set screw.
Temporarily install the faucet onto the supply until the mounting plate is both flush with the wall and the
set screw is facing down.
With a pencil, mark the location of the four mounting holes.
Remove the faucet from the supply.
Remove the mounting plate from the faucet shank.
Drill a 1/4” hole at each of the four marked locations.
Install an anchor into each of the four holes.
Apply thread sealant to the supply pipe threads.
Slide the mounting plate over the supply and up against the finished wall. Position the mounting
plate so the set screw hole is facing down.
Line up the holes in the mounting plate with the anchors and secure with the four screws.