Operation Manual

EN-12 Original User Guide | Pedelec Impulse Evo RS Version 1
If the cycle does not start up despite you
pressing the
button, press the battery
button for 1 second. Then briey press the
button on the easy-reach control. The
Pedelec switches on. If it still does not
switch on, check the battery
 5.2.1 Battery management system (BMS)
Page EN-47.
Battery
button
2.4 Changing assist mode
1. You must be in the start menu to change assist mode. Briey press the
/ buttons to select the assist level.
DISPLAY ASSIST POWER CONSUMPTION
ULTRA
the assist function works extremely
hard
very high
POWER
The assist function works very hard High
SPORT
The assist function works medium
hard
Medium
ECO
The assist function works with low
power
Low
OFF
No assist Very low
The recommendation is to remove the key now and keep it
in a safe place so it does not break o and is not lost.
Make a note of the key number on the sales receipt/
document. This number can be used to order a replacement
key  7.2 Battery Page EN-60.
2.3 Switching on the Pedelec
1. Press for 1 second the button on the
easy-reach control. The display lighting
is switched on for about 30 seconds.
The back light is also turned on. The
front light is turned on when it has been
switched on from the top of the lamp.
After a short time, a welcome screen is
shown, followed by the start menu. You
can congure other settings from here.“
Press the button