Operation Manual

Original User Guide | Pedelec Impulse Evo RS Speed Version 1 EN-63
8.2 Add-on parts not requiring approval
» Cranks
» Pedals (when type-approved pedal reectors are used)
» Mudguards (the front edge of the front mudguard must be rounded)
» Pannier rack
» Saddle
» Handle bars
» Gear change components (only when the highest gear ratio is not
changed)
» Seat post
» Bell (can be changed for another comparable high-pitch bell)
» Mirrors (can be replaced by other type-approved mirrors)
» Chain
» Headset
» Tubes
» Nubs
8. Replacing parts on the S-Pedelec
Because your S-Pedelec is a Class L1e moped, registration approval
from the TÜV and Federal Oce for Motor Vehicles must be sought (as is
the case for other motorised vehicles). This approval is in place for the
S-Pedelec. During the authorisation process, certain parts for which use on
this vehicle is permitted were determined. This means the approval of your
S-Pedelec only remains valid when exactly the same parts as the types
approved are used. If parts are subsequently modied or replaced, the
same specications as for other motorised vehicles take eect. You may
only use replacement parts for which expert reports on approval for your
S-Pedelec are in place. Alternatively, you can have individual approvals
carried out at the TÜV.
Listed below are the parts of your S-Pedelec you may replace with which
specications.
8.1 Add-on parts which may only be replaced by
identical parts or parts with approval
» Frame
» Forks
» Motor unit
» Battery
» Tyres
» Rims
» Brake system
» Front light
» Back light
» License plate holder