Operation Manual
Original User Manual | Pedelec Impulse 2.0 21
Wheel circumference: You can set the “wheel circumfer-
ence” to any value between 1540 mm and 2330 mm by
pressing the
/ buttons on the control panel. Tapping
the
button conrms your selection and then takes you
back to the menu sub-item display.
A change to the setting becomes necessary, for
example, when you have the tyres on your Pedelec
exchanged for some of a dierent size. In order
to continue to display the correct data, the new
wheel circumference must be entered.
Shi Sensor: Choose om the following values using the
/ button.
OFF
50 ms 100 ms 150 ms 200 ms 250 ms 300 ms
Conrm your selection by tapping the
button.
The Shi Sensor recognises gear shiing and
imperceptibly interrupts the power assist for ac-
tions of a second. This enables you to move more
smoothly and considerably faster through the
gears. The higher the value you set, the longer the
assistance is interrupted for, and the more time
there is for shiing gears.
Climb Assist: Choose om the following values using the
/ button.
1 2 3 4 5 6 7
Conrm your selection using the button.
You can inuence the response time of the power
sensor with the Climb Assist. The lower the value
you set, the less responsive the system becomes.
The higher the value you set, the more dynamic
the system becomes, but beware a yo-yo eect.
Brightness: You can select the following values using the
/ button:
Very bright 50%
45%
40%
35%
30%
Average “Standard”
5%
10%
15%
Very dark 20%
The change in brightness is implemented immediately.
Pressing the
button conrms your selection and then
takes you back to the menu sub-item display.
Language: You can choose to have the information shown
on the display in the following languages:
• Deutsch
• English
• Francais
• Nederlands
• Espanol
• Italiano
• Suomi
• Dansk
You can select the relevant language using the
/ but-
tons. Tapping the
button conrms your selection and
takes you back to the menu sub-item display.
Unit: Under the item “Unit”, you can choose whether in-
formation on distance travelled and speed is displayed
in kilometres (km) or miles (mi). Use the
/ buttons to
choose between kilometres (km) or miles (mph). Tapping
the
button conrms your selection and then takes you
back to the menu sub-item display.
7.4.4.2 Drive
Choose om the following using the / button:
• Wheel circumference
• Shi Sensor
• Climb Assist
• Back
Conrm your selection by tapping the button. You are
taken back to the menu sub-item display.