Operation Manual

24 Original User Manual | Pedelec Impulse 2.0 Ergo
Climb Assist: Choose om the following values using the
/ button:
1 2 3 4 5 6 7
Conrm your selection using the
button.
You can inuence the response time of the power sen-
sor with the Climb Assist. The lower the value you set,
the less responsive the system becomes. The higher
the value you set, the more dynamic the system be-
comes, but beware a yo-yo eect.
7.3.4.3 Miscellaneous
Choose om the following using the
/ button:
• Factory settings
• Soware
• Back
Conrm your selection by tapping the
button.
Factory settings: The following question appears: “Restore
factory settings?”. Select “Yes” if you wish to reset the
system to its original settings. Select “No” if you wish to
retain all the settings you have made. Conrm your selec-
tion by tapping the
button.
Soware: This takes you to the items:
• Version
• Update
• Back
Make a selection using the
/ button, then conrm and
go to that item by tapping the button.
• Version: Here the current soware version of the
motor is displayed.
• Update: Here you can bring the soware up to
date. Your specialist cycle shop will perform a
soware update.
Select a language using the / buttons. Tapping the
button conrms your selection and takes you back to
the menu sub-item display.
Unit: Under the item “Unit”, you can choose whether the
distance travelled and speed are displayed in kilometres
(km) or miles (mi). Use the
/ buttons to choose be-
tween kilometres (km) or miles (mph). Tapping the
but-
ton conrms your selection and then takes you back to the
menu sub-item display.
7.3.4.2 Drive
Choose om the following using the
/ button:
• Wheel circumference
• Shi Sensor
• Climb Assist
• Back
Conrm your selection by tapping the
button. This
takes you back to the menu sub-item display.
Wheel circumference: You can set the “wheel circumfer-
ence” to any value between 1540 mm and 2330 mm by
pressing the
/ buttons on the control unit. Tapping the
button conrms your selection and then takes you back
to the menu sub-item display.
A change to the setting becomes necessary, for ex-
ample, when you have the tyres on your Pedelec
exchanged for some of a dierent size. In order to
display the correct data, the new wheel circumference
must be entered.
Shi Sensor: Choose om the following values using the
/ button:
OFF
50 ms 100 ms 150 ms 200 ms 250 ms 300 ms
Conrm your selection by tapping the
button.
The Shi Sensor recognises gear shiing and imper-
ceptibly interrupts the power assist for actions of a
second. This enables you to move more smoothly and
considerably faster through the gears. The higher the
value you set, the longer the assistance is interrupted
for, and the more time there is for shiing gears.