Operation Manual

I General User Manual 29
Installing the shiing cable with hub gears
Bring the cable around to the cassette joint pulley,
hold so that the inner cable xing nut is facing to
the outside (toward the dropout), and then slide
the ats part of the inner cable xing washer into
the gap in the pulley.
Flats part of the inner
cable xing washer
Gap in pulleyInner cable
xing nut
Pulley
CJ-8S20
JAPAN
LOCK
Turn the cable 60° anticlockwise and attach it on
the hook.
CJ-8S20
JAPAN
LOCK
Turn the
cable 60°
Hook
Attach the inner cable to the pulley as shown in the
illustration, pass the inner cable through the slit in
the cassette joint bracket, and then insert the end
of the outer casing securely into the outer casing
holder.
CJ-8S20
JAPAN
LOCK
CJ-8S20
JAPAN
Inner cable
Bracket
Outer casing holder
Slit
Pulley
Bracket
1
2
1 Pass through the slit
2 Insert into the outer casing holder
If rst inserting the outer casing into the outer
casing holder is easier, then rst insert the outer
casing into the outer casing holder, and the insert a
2mm Allen key or a # 14 spoke into the hole in the
cassette joint pulley, and then turn the pulley so
that the inner cable xing bolt unit ts into the gap
in the pulley.
CJ-8S20
JAPAN
LOCK
1
2
3
Hole in pulley
2 mm Allen key
or # 14 spoke
1 Insert into the outer casing holder
2 Turn the pulley
3 Insert the inner cable xing bolt unit