Installation Guide

FR 5300

Installation Instructions

Sanitary ﬁtter

* cut-off, if necessary

The rubber supporting pads (B) and the

rubber holding proﬁles (C) must not be

interchanged.

CHECKING THE ASSEMBLY DIMENSIONS

• Place the shower tray carefully in position and check whether the

installation is impeded by oblique tiles or walls (see note).

• Check the heights of shower tray and shower tray foot frame

(FR 5300).

• Check position and possibility of fastening the siphon trap.

• Carefully remove the shower tray.

Place the shower tray in position with the

help of a second person, using a suitable

installation aid (e.g. „vacuum suction

handles“ used in window construction), if

necessary.

If the walls adjoining the foot frame are

not angular, the supervisor has to be in

formed and remedial action to be taken

(see DIN 18 202 Tolerances in building

construction - Table 2 Angle tolerances.

“The walls must not exceed the tolerance

by more than 6 mm over a length of 1 m“).

MOUNTING OF THE RUBBER SUPPORTING PADS

• Check the FR 5300 for damage and soiling; repair and/or clean

it, if necessary.

• Place rubber supporting pads (A) in position.

• Place rubber supporting pads (B) and/or rubber holding proﬁle (C)

in position.

POSITION OF THE RUBBER SUPPORTING PADS/

RUBBER HOLDING PROFILE

1 = Size up to 120 cm x 120 cm (4x A, 4x C)

2 = Size from 140 cm x 70 cm to 180 cm x

100 cm (4x A, 4x B, 4x C)

3 = Size 150 cm x 150 cm (4x A, 8x B, 4x C)

4 = Size 100 cm x 100 cm ARRONDO/

ZIRKON (3x A, 2x B, 4x C)

5 = Size 100 cm x 100 cm CORNEZZA (3x A,

2x B, 5x C)

A =

4 5