Installation Guide

_______________________________________________________________________________
14074 Trade Center Drive Suite 141 Fishers, IN 46038 (o) 317-774-3226 (F) 866-543-6717
INSTALLATION INSTRUCTION FOR FLUSH KALDEWEI SHOWER PAN WITH PVC OR ABS
DRAIN
1. Frame out shower stall area to shower pan dimensions. Measure the height of your
shower pan. Take this measurement minus the height of your tile and this is how far
the shower tray is to be set into the sub-floor.
2. Sweep out any debris from sub floor.
3. Test fit shower pan drain housing into subfloor bore hole.
4. Make sure the shower pan is aligned properly and fits snuggly against the shower frame
studs on all sides. Install your tile flange on the out side of the shower tray. Please
see tile flange installation instructions.
If there is no access from the subfloor below, then make sure the drainpipe stubbed up
from the subfloor is adjusted to a height sufficient to fit properly into the shower pan drain
connection.
5. Put down a ½”to ¾” mortar bed on the entire framed in subfloor to the edge of the bore
hole.
6. Brush drain adhesive(PVC or ABS as applicable) inside the drain connection located at
the bottom of the drain which is integrated into the shower pan, and
7. Set the shower pan carefully into the mortar bed and the drain housing into the bore
hole in the subfloor.
8. Firmly press the Tile Redi shower pan into place, making sure there is a good seal
between the curb and the subfloor.