Operator's Manual

F1[iURE 18.
FRONT SIGHT
1. . FRONT'S I GHT POST
2. BASE
3. C,OMBINATIONTOOL
4. CYLINDRICAL POST MOUNT
::: ~
-.
~
1
3
SECTION IV. DISASSEMBLY
Un1oadi
ng and c,l
earing the AK-47: Remove the magazi ne and pull
the ope-rati ng handle fully to the re'ar. Inspect the chamber and r-e-
cei \I'er to insure, no cartr
,
idQeS are present. Relea,se the op-erating
handle and pull the trigger (fig 20).
Remove t~e bolt cover: Press the serrated end of the driving
spring guide (fig 21) into the bolt cover, and while holding the guide
in!8 1ift off the bol t cover, rear end first {fig
22) ~
Remove
the driving spring assembly:
Push
forward on the end of
the driving spring guide (fig 23), disengagi,ng it from i:ts seat in
the rear of the receiver (f';g 24); the,n pull' the c.OOlplete driving
spring assembly out of the bolt carrier (fig
25).
Re
,
mDve
b-olt and carrier: Pull the OP
,
erati ng handle fullr to the
rear (fig 2-5)~ lift the bolt carrier slightl,y
upwar'd
(fig 27) and
tl1en
remove
thE: bolt and carrier by pulling it to the rear (fig
28).
R~mnve
the bolt from the carrier: Press the bolt into the car-
rier' (fig 29) until the bolt operating 1ug carl be twisted fre'e of i't-s
eam pa,th
in the carr; er (fig 30) ~ Pull the bol t straigl1t forward. a.nd
out of the carrier (fig 31).
Remove
gas cyllnder tube; Rotate the gas cylinder tube lock up-
ward (fig 32 and 33} to free the gas cylinder tube. Pull up on the
rear'
of the hand guard
and r'emove
the tube
(fi g 34).
2,
f
-\.-
...
.....
~. .
-
III
j -
-.. -~
1
"
",:
~:
,:
~
.~
~ . I
Fl G,URE 19~ FRONT SIGHT
1 .
2.
FRONT SIGHT BASE
SPE CI Al.
TOOL
13
14