Wine Cooler INSTRUCTION MANUAL Model No：KRC-120WB To ensure proper use of this wine cooler and your safety, please read the following instructions completely before operating this appliance. THIS APPLIANCE IS INTENDED TO BE USED EXCLUSIVELY FOR THE STORAGE OF WINE.
TABLE OF CONTENTS BEFORE FIRST USE………………………………………………………… 2 IMPORTANT………………………………………………………………...... 2 PLACING AND INSTALLATION…………………………………………….. 3 DESCRIPTION OF THE APPLIANCE………………………..…………….. 4 TEMPERATURE CONTROL.…………….………………………………….. 5 MAINTENANCE AND CLEANING………………………………………...... 6 TROUBLE-SHOOTING GUIDE …………………………………………….. 7 Thank you for buying this appliance. We hope it will successfully serve your requirements for many years.
BEFORE PUTTING INTO USE Before connecting the appliance to electrical power supply, leave it to stand for about 2 hours, which will reduce the possibility of malfunctions in the cooling system due to transport handling. Clean the appliance thoroughly; especially in the interior (See Cleaning and Maintenance). In case the interior accessories are not correctly placed, rearrange them as described in chapter "Description of the Appliance".
located either inside the appliance or outside on the rear wall. This appliance can not be used in camping. Warning: Keep ventilation openings in the appliance enclosure or in the built-in structure clear of obstruction. Warning: Do not use mechanical devices or other means to accelerate defrosting process, other than those recommended by the manufacturer. Warning: Do not damage the refrigerant circuit.
Installation Place the appliance firmly on a solid base. Some appliances have adjustable feet on the front side; use them to level the appliance. Wiring Instructions For your personal safety, this appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a power cord having an earthing conductor.
Adjustable Wire Shelves Shelves can be optionally placed on the guides inside the appliance where appropriate. To remove a rack: 1. Remove all bottles from the rack. 2. Lift the rack upwards and then pull out. To replace: Put the sides of the rack back onto the supporting bar of the cabinet and push backward until the rack tabs embeded into place. Note: Make sure the tabs on the rack are well embeded in place before loading any bottles.
2. After the second beep, press the “+” and “–” pads to increase or decrease the desired temperature in increments of one degree. During this time the display will flash. 3. Press SET to confirm your choice. The display will stop flashing. If no confirmation is made in ten seconds, the unit will automatically accept your change. NOTE: When you change the temperature setting, there may be a 5-minute delay until the compressor starts to run.
TROUBLE-SHOOTING GUIDE Sometimes you may come across minor problems that in most cases do not require a service call and can be easily eliminated. The problem may have resulted from improper handling and / or installation of the appliance. Please refer to the below trouble-shooting guide to assist you in identifying the possible cause and solution to your problem. Should the problem still persist after completing these checkpoints, contact the closest authorized service agent in your area for assistance.
is. During the operation of the compressor the noise of the liquid is heard and when the compressor is not operating, the refrigerant flow is heard. This is a normal condition and it has no influence whatsoever on the lifetime of the appliance. After starting the appliance, the operation of the compressor and the refrigerant flow may be louder, which does not mean that something is wrong with the appliance and it has no influence on the lifetime of the appliance. Gradually the noise will reduce.
To obtain service or information, please call 866-554-6688 or send email to service@kalamera.com Product contents and specifications may change without notice. Copyright © 2021 Kalamera Inc www.kalamera.
