Owner's Manual
KalamazooGourmet.com48
Installing with the Kalamazoo Signature Series
Cabinetry Collection
The built-in Kalamazoo Smoker Cabinet is built to the same specifications as the Kalamazoo Weather-tight
Signature Series Outdoor Kitchen Cabinetry Collection and can be installed as part of this system.
Warning: Do not leave the built-in smoker outside without the protection of an installed countertop. If
the smoker will be exposed to rain prior to installing the countertop, please keep it covered.
IMPORTANT INSTALLATION NOTES:
The space between the right side of the upper structure that protrudes through the countertop
and the right side of the main cabinet body is only one inch wide. This is not enough for a typical
countertop section. If installing the smoker at the right end of a cabinetry or masonry run, additional
space and support will be needed to the right end of the smoker to support an adequate minimum
countertop section. We recommend purchasing the 3-inch right-end panel that is available for these
specific situations.
Do not install the smoker cabinet immediately adjacent to the left side of a grill. We recommend
purchasing the 4-inch filler panel to create the required separation.
CONNECT ADJACENT CABINETS
AT LOWER FRONT AND REAR WITH
INCLUDED BUTTON-HEAD CAP SCREWS
AND FLANGE NUTS
CONNECT ADJACENT CABINETS
AT UPPER FRONT AND REAR WITH
INCLUDED SPEED CLIPS










