Installation Guide

the sealant is coated on the edge of the
drain pipe, the silicone sealing ring is
stuck on the edge of the drain pipe.
Install the rubber washer and metal
washer onto the threaded mounting
shank. Thread the nut onto the mounting shank.
Lock the nut into position by tightening the
screws. Do not overtighten.
Push the quick connector firmly upward
and attach it to the receiving block. Pull
down moderately to ensure the connection
has been made.Install the Weight & Clip
Assembly.
Thread the nut on the supply line onto the
outlet of the water supply valve and
tighten with a wrench. Do not overtighten.
Insert the faucet into the sink opening
and adjust.
Remove mounting hardware from faucet
body.
Install hot and cold water pipes
The drain pipe is aligned with the opening
of the sink, pay attention to the screw hole
of the drain pipe.
Use a screwdriver to fix the screw on the
edge and strengthen the drain pipe;
Connect the drainage hose to the
drainage port.
For all treated surfaces, wash the entire surface with mild soap
and water, then dr y the entire surface with a clean, soft cloth.
Cleaning products that contain ammonia, decontamination
powder, and products used on surfaces such as bathrooms
should not be used, as they may damage galvanized surfaces.
Abrasive cleaners or detergents should also not be used on
faucets and accessories.
Cleaning instructions
1
5 6
7
8
9
10
2 3 4