Use and Care Manual

Hose / Regulator
connection
Regulator / Cylinder
connection
Page 11 of 16
LEAK CHECK
1.
NEVER USE A LIGHTER/FLAME TO CHECK FOR GAS LEAKS.
2.
Make 2-3 oz. of leak check solution (one part liquid dishwashing
detergent and three parts water).
3.
Apply several drops of solution where hose attaches to regulator.
4.
Apply several drops of solution where regulator connects to cylinder.
5.
Make sure all fire pit and light valves are OFF. And turn cylinder valve ON
1).
Turn cylinder valve OFF.
If leak is at hose/regulator connection: tighten connection and perform
another leak test. If bubbles continue appearing, the hose should be
returned to the place of purchase.
2
).
If leak is at regulator/cylinder valve connection: disconnect, reconnect,
and perform another leak check. If you continue to see bubbles after
several attempts, cylinder valve is defective and should be returned to
cylinder’s place of purchase.
Operation
If
bubbles appear at any connection, there is a leak.
If NO bubbles appear at any connection, the connections are secure.
NOTE: Whenever gas connections are loosened or removed, you must
perform a complete leak test. Complete installation.