Installation Sheet

8 9
G-2 Determine the proper tailpiece (d) from the chart below for your KIL
cylinder.
You must use a factory shortened Kaba tailpiece.
The shortened K 2 tailpiece is preassembled with the Kaba 1599.
G-3 Assemble the required tailpiece (d) (supplied with your KIL cylinder.
All tailpieces must be installed vertically for proper
installation, as shown.
G-4 Insert the KIL cylinder into the outside lever (b)
and secure it with the cylinder retainer (c) and
cylinder insert (e) until the KIL cylinder is
snug and unable to move freely.
H. INSTALLING / REMOVING
OUTSIDE LEVER
(Key-In-Lever models only)(For interchangeable
and removable cores proceed to section I)
Note: Installing levers to the unit assemblies
before mounting the unit assemblies may
ease initial installation.
H-1 Make certain the lever catch is up as shown (c).
Position the lever sleeve (f) tab correctly with the
respective notch on the lever. The lock comes shipped
with the lever sleeve already installed in the lock
housing. When installing lever, ensure it is oriented to
engage the lever sleeve to accommodate desired lock
handing as shown.
H-2 Insert one of the (supplied) keys (a) into the outside
lever (b) and rotate key counterclockwise 45 degrees.
H-3 Insert the outside lever (b) until it is flush to the outside
unit assembly. Secure the outside lever by rotating the key
clockwise 45 degrees to horizontal position. Remove key.
Note: To remove the outside lever from the
outside unit assembly, follow the steps below.
H-4 Insert one of the (supplied) keys (a) into the outside lever
(b) and rotate it counterclockwise 45 degrees. Insert
release tool (d) into the small hole (e) under lever as
shown. Gently push lever catch up until it clicks. Remove
tool, then remove outside lever (b).
I. INSTALLING / REMOVING OUTSIDE LEVER
(Interchangeable / Removable Core Models)
Note: Installing lever to the unit assemblies
before mounting the unit assemblies may
ease initial installation.
I-1 Make certain the lever catch is up as shown (c).
Position the lever sleeve (f) tab correctly with the
respective notch on the lever. The lock comes shipped
with the lever sleeve already installed in the lock
housing. When installing the lever, ensure it is
oriented to engage the lever sleeve to
accommodate desired lock handing as shown.
I-2 Insert the outside lever (b) until it is flush to the outside
unit assembly (a). To secure the outside lever, insert the
release tool (d) (or screw driver) into the outside lever as
shown, and slide the lever catch down until it clicks. Make
certain lever is attached before installing the core.
Assa 65611, Australian: Kaba experT 107K5 &
Boyd KC286, Corbin-Russwin 2000-03, Kaba
1599, Schlage 23-001, Schlage Primus 20-760,
Kaba Peaks 1099
Medeco 20W200H1
Arrow C100, Sargent 10 LINE
Marks
Abloy 5277, Abloy 5477, Assa 65691,
Kaba 1539, Kaba Gemini 4730
KIL CYLINDERTAILPIECE
b
a
c
e
d
b
a
45º
a
b
d
e
LH
KIL Lever Sleeve
RH
f
c
Correct
Position
Incorrect
Position
c
Correct
Position
Incorrect
Position
RH
LH
IC Lever Sleeve
f
d
a
b