User's Manual

Remove a spent or discharged battery from the product. Remove the battery
when not using the product for an extended period.
Never throw batteries into a fire. Do not expose batteries to fire or other heat
sources.
Battery contains mercury. Do not put in trash. Recycle or manage as hazardous
waste.
Battery Replacement
Remove the Battery compartment cover from the back of the remote control by
sliding the cover in the direction that its treads curve.
Remove the spent battery and place a new DC 12V Type 23A battery into the
battery compartment, correctly observing the polarity indications (+/−) inside the
battery compartment.
Replace the battery compartment cover.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures :
Reorient or relocate the receiving antenna.