User's Manual

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions:
(3) This device may not cause interference; and
(4) This device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This radio transmitter IC: 4494A-ECOPLUGS has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Antenna General Information
Ant. Cat. Ant. Type Gain
(
dBi
)
External Dipole 2.33
External Printed -4.88
Le présent émetteur radio IC: 4494A-ECOPLUGS a été approuvé par Industrie Canada pour fonctionner avec les types
d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les
types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits
pour l'exploitation de l'émetteur.
Antenna General Information
Ant. Cat. Ant. Type Gain
(
dBi
)
External Dipole 2.33
External Printed -4.88
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm
may be maintained between the antenna and users. The final end product must be labeled in a visible area with
the following: “Contains transmitter module IC: 4494A-ECOPLUGS”.
Contient le module d'émission IC: 4494A-ECOPLUGS