Phau Ntawv Qhia

11Instruction manual TBU850 / TBU520 Please keep this instruction manual for future reference
› Make a cut-out in the bottom of the cabinet of the
following sizes:
TBU520: 265mm x 498mm
TBU850: 265mm x 835mm
Make sure the cabinet structure and the material used
allow you to make this opening without causing any
damage, even during the appliance installation.
› Prepare the power supply.
› Create a hole for air evacuation.
› Remove the fixing screws of the rear steel bar (Fig.5).
› Rotate the steel bar (including the LED bar) to remove it from its position (Fig.6-7).
Electrically disconnect the the LED Bar.
Make a cut-out in the bottom of the cabinet of the following sizes:
TBU520: 265mm x 498mm
TBU850: 265mm x 835mm
Make sure the cabinet structure and the material used allow you to make
this opening without causing any damage, even during the appliance
installation.
Prepare the power supply.
Create a hole for air evacuation.
Remove the fixing screws of the rear steel bar (Fig.5).
Rotate the steel bar (including the LED bar) to remove it from its position
(Fig.6-7). Electrically disconnect the the LED Bar.
Insert the appliance into the hole made in the cabinet and fix it by inserting the screws supplied into the holes (Fig.8).
Refit the stainless steel bar, electrically connect the LED bar and refit the grease filter.
FIG.5
6
7
Connect the flange to the air evacuation hole with appropriate ducting.
Connect the appliance to the electrical mains through the supply cord.
RECIRCULATING
Connect the flange with appropriate ducting to convey the air to the top of the cabinet.
Connect the appliance to the electrical mains through the supply cord.
8
Make a cut-out in the bottom of the cabinet of the following sizes:
TBU520: 265mm x 498mm
TBU850: 265mm x 835mm
Make sure the cabinet structure and the material used allow you to make
this opening without causing any damage, even during the appliance
installation.
Prepare the power supply.
Create a hole for air evacuation.
Remove the fixing screws of the rear steel bar (Fig.5).
Rotate the steel bar (including the LED bar) to remove it from its position
(Fig.6-7). Electrically disconnect the the LED Bar.
Insert the appliance into the hole made in the cabinet and fix it by inserting the screws supplied into the holes (Fig.8).
Refit the stainless steel bar, electrically connect the LED bar and refit the grease filter.
5
FIG.6
FIG.7
Connect the flange to the air evacuation hole with appropriate ducting.
Connect the appliance to the electrical mains through the supply cord.
RECIRCULATING
Connect the flange with appropriate ducting to convey the air to the top of the cabinet.
Connect the appliance to the electrical mains through the supply cord.
FIG.8
› Insert the appliance into the hole made in the cabinet and fix it by inserting the screws
supplied into the holes (Fig.8).
› Refit the stainless steel bar, electrically connect the LED bar and refit the grease filter.
WARNING:
› Before connecting the flexible exhausting pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can open and close freely.
The cooker hood should be placed at a minimum distance of 65cm above the hob. It is the
manufacturer of the hob who determines the clearance required and the clearance quoted by
the hob manufacturer must be followed. In the absence of any instructions supplied with a gas
hob the minimum distance between the hob and the hood must be at least 760mm.