To u c h C o n t r o l B u i l t - U n d e r Hood Instruction Manual TBU850 / TBU520 Contact Caple on 0117 938 7420 for spare parts or www.caple.co.
CONTENTS Safety Instructions 3 Environmental Protection 7 Uses 9 Installation 8 Control Panel 13 Timing 14 Cleaning and Maintenance 15 Caple Contact Details 20 2 Instruction manual TBU850 / TBU520 Please keep this instruction manual for future reference
WARNING - The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure they do not play with the appliance. - The cooking surface and the inferior part of the cooker hood must be at a minimum distance of 65 cm. - The extracted air can’t be conveyed through or into a duct used to let out fumes from appliances fed by energy other than electric power (eg. centralized heating, radiators, water-heaters, etc.).
- When performing the electrical connections on the appliance, please make sure that the current tap is provided with earth connection and that voltage values correspond to those indicated on the rating label placed inside the appliance itself. - Before carrying out any cleaning or maintaining operations, the appliance needs to be removed from the electric grid.
- The cooker hood is not intended for outdoor use. - It must only be used as a domestic appliance to extract vapours and remove odours from cooking. Any other usage is not supported by the manufacturer and could be dangerous. - Where a recirculation cooker hood is fitted above a gas hob, please ensure that there is an adequate supply of fresh air into the room in which it is installed. Please seek the advice of a qualified gas fitter (e.g. GasSafe in the UK) if necessary.
- Do not touch the housing or the grease filters until the cooker hood has cooled down. A P P R O P R I AT E U S E : - This appliance is intended to be used in household and similar applications such as: › Staff kitchen areas in shops, offices and other working environments. › Farm Houses. › By clients in hotels, motels and other residential type environments. › Bed and breakfast type environments.
E N V I R O N M E N TA L P R OT E C T I O N Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. This appliance is marked according to the European directive on Waste Electrical and Electronic Equipment (WEEE).
TECHNICAL FICHE This appliance conforms to all current and applicable energy regulations. To view the Technical Fiche that supports the energy labelling data, please visit the product page on our website www.caple.co.uk.
USES The appliance is already arranged both for re-circulation and ducted installation. › In Recirculation mode (Fig.1), the air and fumes conveyed by the appliance are cleaned both by a grease filter and by an active charcoal filter, and put again into circulation through the hole made in the top of the cabinet. › In ducted mode (Fig.2), fumes are directly conveyed outside, through an evacuation duct connected from the extractor to the outside.
I N S TA L L AT I O N Before installing the appliance, make sure that none of the parts are damaged in any way. In case of damaged parts, contact your retailer and do not proceed with installation. Read all of the following instructions with care before installing the appliance: › If venting the hood, use an air outlet pipe of the shortest possible length. › Limit the number of pipe bends. › Use a duct of recognised and approved material.
› Make a cut-out in the bottom of the cabinet of the Make a cut-out in the bottom of the cabinet of the following sizes: following sizes: TBU520: 265mm x 498mm TBU520: 265mm x 498mm TBU850: 265mm x 835mm Make sure265mm the cabinetxstructure TBU850: 835mmand the material used allow you to make Make a cut-out in the bottom of the cabinet of the following sizes: this opening without causing any damage, even during the appliance TBU520:sure 265mm 498mm structure and the material used Make thex cabinet instal
DUCTED VERSION › Connect the flange to the air evacuation hole with appropriate ducting. › Connect the appliance to the electrical mains through the supply cord. R E C I R C U L AT I N G V E R S I O N › Connect the flange with appropriate ducting to convey the air to the top of the cabinet. › Connect the appliance to the electrical mains through the supply cord. REAR DUCTED VERSION › To duct the appliance to the rear, remove the 18 screws from the motor support.
9 10 CCOONNTTRROOLL PA PANNE EL L A B C D E A: Light switch on/off A.Reduce Light speed switch/on/off B: OFF motor C: Motor speed display B. Reduce speed / OFF motor D: ON motor/increase speed E: timerdisplay C.10-minute Motor speed D. ON motor/increase speed NOTE: timer supply to the appliance is cut, allow 15 seconds for the functions to restore prope IfE.the10-minute electrical power meantime, the operation may be incorrect.
TIMING › This product is equipped with intelligent electronics which include a timer device for speed controls when the air capacity exceeds 650m³/h. Internal motor models, with maximum air capacity higher than 650m³/h, are equipped with a timer device that automatically switches the speed from 4th to 3rd speed, after 5 minutes operation. › External motor models are equipped with remote motors that, as for internal motor versions, include a timer device that switches down the speed when it exceeds 650 m³/h.
CLEANING AND MAINTENANCE › Accurate maintenance guarantees good functioning and long lasting performance. › Particular care must be made when handling the grease filter panel. It can be removed by pushing its handle toward the back-side of the cooker hood and turning the filter downwards so to unfasten it from its slot (Fig.4). To insert the filter just perform the opposite operation.
FIG.3 › The LED lights must be replaced only by a qualified or competent person. › If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. FIG.6 FIG.6 FIG.7 FIG.7 FIG.4 4 FIG.12 12 FIG.8 FIG.8 FIG.8 FIG.
REPLACING LED LIGHTING LIGHTSOURCE SOURCE ENERGY CLASS LIGHT ENERGY CLASS This product a alightlight source of energy efficiency class F.class F. This productcontains contains source of energy efficiency LIGHT ENERGY CLASS LIGHT SOURCE ENERGY CLASS LIGHTSOURCE SOURCE ENERGY CLASS LIGHT SOURCE ENERGY CLASS This product contains a alight source of energy efficiency class F. F.
N OT E S : 18 Instruction manual TBU850 / TBU520 Please keep this instruction manual for future reference
N OT E S : Please keep this instruction manual for future reference Instruction manual TBU850 / TBU520 19
Caple Service Fourth Way Avonmouth Bristol BS11 8DW T: 0117 938 1900 E: service@caple.co.uk www.caple.co.
