Wa l l C h i m n e y H o o d Instruction Manual FGC620 FGC720 FGC920 Contact Caple on 0117 938 7420 for spare parts or www.caple.co.
CONTENTS Introduction 3 Safety Instructions 4 Environmental Protection 9 Installation 10 Operation 16 Care and Maintenance 17 Troubleshooting 19 Product Dimensions 20 Caple Contact Details 24 2 Instruction manual FGC620 FGC720 FGC920 Please keep this instruction manual for future reference
INTRODUCTION Thank you for choosing this Caple extractor hood. To ensure that you get the best results from your new extractor, we strongly suggest that you read this instruction manual thoroughly before use. If treated with care, your Caple extractor should give you years of troublefree use. To register ownership, please ensure you complete and return the guarantee card supplied with the appliance or visit www.caple.co.uk and register here.
I M P O R TA N T This appliance must only be used for the purpose it is intended. Other types of use are not permitted and may prove dangerous. Caple will not be held liable for any damage caused by the incorrect use of the appliance. Do not use any accessories or attachments not recommended by Caple as this may result in fire, electric shock or injury. To protect against fire, electrical shock and injury to persons, do not immerse cords or plugs in water or any other liquid.
I M P O R TA N T Caple cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that Caple reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel. SAFETY INSTRUCTIONS - Never let children operate the machine.
- The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. - Regulations concerning the discharge of air have to be conformed to. - Do not flambé under the cooker hood. - Never leave frying pans unattended during use as overheated fats and oils may catch fire. - To ensure the best performance, we recommend switching on the extractor 15 minutes before cooking and leave it running 15 minutes after.
- Never immerse the appliance in water. - This appliance is intended to be used in household and similar applications such as: › Staff kitchen areas in shops, offices and other working environments. › Farm Houses. › By clients in hotels, motels and other residential type environments. › Bed and breakfast type environments. - To avoid all risk, if the power cable is damaged, it must only be replaced by a Caple appointed engineer.
ELECTRICAL SHOCK HAZARD - Only plug this unit into a properly earthed outlet. If in doubt seek advice from a suitably qualified engineer. - Failure to follow these instructions can result in death, fire, or electrical shock. - This appliance must be connected to the mains by a competent person. We recommend that the appliance is connected by a qualified electrician who is a member of the N.I.C.E.I.C who will comply with the I.E.E and local regulations.
E N V I R O N M E N TA L P R OT E C T I O N Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. This appliance is marked according to the European directive on Waste Electrical and Electronic Equipment (WEEE).
I N S TA L L AT I O N P R E PA R E F O R T H E I N S TA L L AT I O N : If you have an outlet to the outside, your cooker hood can be connected as per the below picture by means of an extraction duct with an interior diameter of 1
I N S TA L L AT I O N - D U C T E D RN I NG: WA the concerning the operation of the appliance when air is discharged from Observe warning the room.
After hanging the hood on the bracket, remove the grease filters, mark 2 holes inside the hood for safety screws. After marking, remove the hood, drill two holes and insert 2 wall plugs and finally fix the safety screws with 2 screws (ST4x30mm).
C H I M N E Y I N S TA L L AT I O N Place the upper chimney into the lower chimney.
charcoal filters must be installed. I N S TA L L AT I O N – R E C I R C U L AT I O N M O D E If you do not have an outlet to the outside, the exhaust pipe is not required (as shown in the section “Installation - ducted”), and charcoal filters must be installed.
N OT E : Make sure the filter is securely locked. Otherwise, it may loosen and be dangerous. When using a charcoal filter, the extraction power may be slightly reduced. We recommend replacing these filters every 6 months. Replacement filters (CAP61CF) can be purchased directly from www.caple.co.
O P E R AT I O N O F F B U T TO N Switches the extraction fan off.
CARE AND MAINTENANCE I M P O R TA N T: Before cleaning or maintenance please switch off the electricity supply and remove the plug from the wall. REGULAR CLEANING Use a soft damp cloth with lukewarm mildly soapy water or household cleaning detergent. Never use metal pads, chemicals, abrasive material, abrasive cleaning creams or stiff brushes to clean the appliance. C L E A N I N G T H E G R E A S E F I LT E R Clean the filter every month to help minimise the risk of fire.
REPLACING THE BULB N OT E : The lights must be replaced by a qualified person. 1. Switch the unit off and unplug the appliance. 2. Remove the lamp cover by unscrewing the 2 screws. 3. Replace with the same type and rated bulb/lamp fixing. LED lamp (max.1.5W).
T R O U B L E S H O OT I N G FA U LT The lights on, but the fan does not work The lights and fan do not work CAUSE SOLUTION The fan blade is jammed. The motor is damaged. Switch off the unit and contact Caple Service. To be repaired by qualified service personnel only. A blown fuse. Replace the fuse. The power cord is loose. Plug in to the power supply again. The fan blade is damaged. Serious vibration of the unit The extraction performance is not good The fan motor is not fixed tightly.
PRODUCT DIMENSIONS @capl FGC620 FGC620 FG C720 FGC920 323mm 280mm 526 -1000mm 500m m 46mm 450mm 595/695/895mm 20 Instruction manual FGC620 FGC720 FGC920 Please keep this instruction manual for future reference
Please keep this instruction manual for future reference Instruction manual FGC620 FGC720 FGC920 21
N OT E S : 22 Instruction manual FGC620 FGC720 FGC920 Please keep this instruction manual for future reference
N OT E S : Please keep this instruction manual for future reference Instruction manual FGC620 FGC720 FGC920 23
Caple Service Fourth Way Avonmouth Bristol BS11 8DW T: 0117 938 1900 E: service@caple.co.uk www.caple.co.
