Product Manual
WR100 instr v.121024
Model / Modèle :
WR100
Instructions Français au verso
DETAIL MERCHANDISING INC.
Wireless Remote Conversion Kit
for K2 Snowplow winch
Connection Instructions
Caution!Before working on the winch or the wiring in your vehicle, disconnect the battery and any other
power sources. Disconnect the original winch control box for the wired-in remote switch from the vehicle battery
and from the winch’s wiring harness connector.
1. In the vehicle’s engine compartment, on the original winch control box, disconnect the wired-in remote switch from the
socket (shown at C on the new unit).
2. Remove the original winch control box from the vehicle’s engine compartment.
3. Replace it with the new control box (A) with the small black case (B) piggy-backed on it.
4. Run the winch power forward out of the engine compartment and after removing the dust cap, connect the new winch
control box using connector (D) to the matching winch wiring harness connector.
5. Wire the new winch control box to the battery at E.
6. You can now use the key fob (F) to control the winch operation.
note:Difculties with your Detail Merchandising K2 plow, winch, or remote conversion kit? Please refer to the
troubleshooting tips in the plow and winch manuals. They are intended as a guide to assist in resolving some common
technical problems and making helpful simple adjustments. For more assistance, please contact, toll-free, the Detail
Merchandising K2 customer service department at 1(888) 277.6960.