Troubleshooting Guide

ManualsBrandsK2 ManualsBattery Back-up Sump Systems573 GPH Water Powered Backup Sump Pump

K2pumps.com

SUMP & PEDESTAL PUMP

Questions, problems, missing parts?

Call K2 Pumps Customer Service 8 am - 6 pm, Monday - Friday

844.242.2475

www.K2pumps.com

Problem 1: Pump will not start or run ..................................................... Page 2

Problem 2: Pump operates but delivers little or no water .................... Page 3

Problem 3: Pump starts and stops too often .......................................... Page 3

Problem 4: Pump will not shut off .......................................................... Page 4

Problem 5: Pump runs loud ..................................................................... Page 4

Problem 6: Circuit Breaker trips when pump starts .............................. Page 4

Summary of content (4 pages)

PAGE 1
K2pumps.com SUMP & PEDESTAL PUMP Troubleshooting Guide Problem 1: Pump will not start or run ..................................................... Page 2 Problem 2: Pump operates but delivers little or no water .................... Page 3 Problem 3: Pump starts and stops too often .......................................... Page 3 Problem 4: Pump will not shut off .......................................................... Page 4 Problem 5: Pump runs loud .............................................
PAGE 2
K2P 2 Sump & Pedestal Pump Troubleshooting Guide SAFETY INSTRUCTIONS All electrical work should be performed by a licensed electrician. WARNING: Risk of electrical shock. Disconnect power to the pump before servicing. Do not handle the pump with wet hands or when standing on a wet or damp surface. WARNING: Risk of fire or explosion. Pump water only with this pump. Do not use this pump in the presence of flammable or explosive vapors. CAUTION: Motors run hot.
PAGE 3
K2P 3 Sump & Pedestal Pump Troubleshooting Guide Problem 2: Pump operates but delivers little or no water Possible Causes Corrective Action 1. Debris is caught in the impeller, pump inlet or discharge pipe 1. Remove the debris. Refer to the "Care and Cleaning" instructions in your manual 2. Impeller is loose on the shaft 2. Reassemble the impeller and be sure it is secured to the shaft 3. Impeller is damaged or broken 3. Replace the Impeller 4. Check valve is installed backwards 4.
PAGE 4
K2P 4 Sump & Pedestal Pump Troubleshooting Guide Problem 4: Pump will not shut off Possible Causes Corrective Action 1. The float switch is stuck in the ON position 1. Remove any obstructions and make sure the float switch can move freely 2. Submersible sump only - the float switch failed* 2. Replace the float switch* 3. More water is flowing into the sump basin than the pump can handle. 3. Replace the pump with one that has a higher GPH and flow rate, or add a backup pump to the sump basin 4.