Material Safety Data Sheet

Safety Data Sheet
(UN GHS Format Compliant)
Safety Data Sheet
Doc Number:
K2S-SDS-0021
Title:
LFP Battery Pack SDS, Low V, Small-Size
Sheet 3 of 10
Revision:
5
Section 3 - Composition/Information on Ingredients
As manufactured and under normal use, this battery is not expected to expose user to hazardous ingredients.
USA: This item is an article pursuant to 29 CFR 1910.1200 and, as such, is not subject to the OSHA Hazard
Communication Standard requirement. The information contained in this Safety Data Sheet contains valuable
information critical to the safe handling and proper use of the product. This SDS should be retained and available
for employees and other users of this product.
Canada: This is not a controlled product under WHMIS. This product meets the definition of a “manufactured
article” and is not subject to the regulations of the Hazardous Products Act.
European Communities (EC): This product is not classified as hazardous according to Regulation (EC) No.
1272/2008. This product contains dangerous ingredients however, there is no expected release during use of the
product and there is a barrier preventing exposure of the user and the environment.
Any hazardous ingredients will only be contained in the sealed battery cell components within the battery pack.
All other component parts of the battery pack are inert materials that do not pose any hazard under normal use
and handling. The following chart is the material content of typical material make up of a component cell.
Common Chemical Name
CAS #
Percent of
Content (%)
Classification and Hazard Labeling
Lithium Iron Phosphate (LiFePO4)
15365-14-7
25-35
Eye, Skin, Respiratory Irritant
Carbon, as Graphite
7440-44-0
12-18
Eye, Skin, Respiratory Irritant
Aluminum Metal
7429-90-5
3-7
Inert
Copper Metal
7440-50-8
5-9
Inert
Electrolyte:
Mixture: Flammable; Reactive; Sensitizer; Eye, Skin &
Respiratory Irritant
Ethylene carbonate
96-49-1
3-5
Dimethyl carbonate
616-38-6
3-5
Ethyl methyl carbonate
623-53-0
3-5
Lithium Hexafluorophosphate
21324-40-3
1-3
Polypropylene
9003-07-0
2-3
Inert
Mild steel can & cap
Not applicable
18-22
Inert
Section 4 – First Aid Measures
Voltage Shock and Burn:
Treat per standards for high voltage/current electric shock and burns. Contact
medical professional immediately.
Skin Contact:
Contact with internal contents of the component cell may cause burns. If skin
contact with internal contents occurs, remove affected articles of clothing.
Wash affected area with lukewarm water for at least 30 minutes. If irritation or
pain persists, seek medical attention. Decontaminate affected articles of
clothing before reuse or discard.
Eye Contact:
Contact with internal contents may cause burns. If eye contact with internal
contents occurs, wash out affected eye with gentle flowing lukewarm water
while holding eyelids open for at least 30 minutes. Rinse with neutral saline
solution if possible. Use caution not to rinse contaminated water into the
unaffected eye, nose, mouth, or onto the face. Seek medical attention.