User's Manual

U
M10936
P
N7150 User Manual
UM
10936 All information provided in this document is subject to legal disclaimers.
U
ser manual
CO
MPANY PUBLIC
Rev. 2.0 — 6 November 2020
348120
55 of 127
C
ommand
M
ain Parameters
V
alues
M
ode Poll
RF Interface Frame
CO
RE_SET_CONFIG_CMD
PB_AFI
PB_
BAIL_OUT
1
PB_
SENSB_REQ_PARAM
2
RF
_DISCOVER_CMD RF Technology & Mode NFC_B_PASSIVE_POLL_MODE
* No
te: RF_DISCOVER_MAP_CMD is optional since the mapping to Frame RF Intf. is done by default
1
t
his parameter is not active in PN7150: it can be read/written, but PN7150 will always
behave with Bail Out in NFC-A, whatever the value written by the DH to that parameter.
2
t
his parameter is not supported in PN7150: STATUS_INVALID_PARAM will be returned
to the DH if it attempts to write this parameter.
6.
3.2 Access through the ISO-DEP RF Interface
T
he ISO-DEP RF interface allows full access to all the Tags based on NFC-A & NFC-B
technology and supporting the ISO-DEP protocol, leaving up to the PN7150 to manage the
ISO-DEP protocol:
T
able 47. Tag/Cards accessible over the ISO-DEP RF Interface
T
ag/Card
Access through the ISO-
D
EP RF Interface
T
4T 
MIFARE DESFire 
MIFARE Plus for Security levels 3 
J
COP-based smart cards 
H
ere are the commands and configuration parameters to prepare the Reader/Writer Mode
for ISO-DEP through the ISO-DEP Interface for technology NFC-A:
Table 48. Config. seq. for R/W of NFC-A / ISO-DEP through the ISO-DEP interface
C
ommand
M
ain Parameters
V
alues
RF_DISCOVER_MAP_CMD
RF Protocol PROTOCOL_ISO-DEP
Mode Poll
R
F Interface ISO-DEP
CORE_SET_CONFIG_CMD
PA_BAIL_OUT
1
PI_BIT_RATE
PA_
ADV_FEAT
3
RF
_DISCOVER_CMD RF Technology & Mode NFC_A_PASSIVE_POLL_MODE
1
t
his parameter is not active in PN7150: it can be read/written, but PN7150 will always
behave with Bail Out in NFC-A, whatever the value written by the DH to that parameter.