Data Sheet

Firmware programming
MAC address
Unless otherwise instructed, each PRBMD00 will be shipped with KATP pre-
programmed but no MAC address is pre-programmed. User can program their own
MAC address by PhyPlusKit. It is important to be reminded that MAC address can be
only writen once and cannot be re-writen.
PRBMD00 DATASHEET 1.5
K-SOLUTION
19
USB-UART dongle
Tx
Rx
3.3V
Note: Some USB-UART dongle may have different
definition of Tx and Rx, can swap these pins if not
success
PhyPlusKit interface
Note: More information will be described in PRBMD0x Programming document.
* MAC address can be programmed by PHY Plus Kit only, and it can be programmed for one time only.
# Reset is needed to leave the AT+RX=c and AT+TXa=b command.