User's Manual
16 | EN
PROGRAMMED DISC PLAY (FOR CD/MP3)
The program function allows you to select up to 20 songs to be played in a specic order. To do so, the
CD playback must be in stop mode.
1. Press the STOP button to stop CD playback.
2. Press the PROG button. Select a track number using ►►| NEXT or |◄◄ BACK button to select
a track which is to played rst in your order. Then press PROG button again.
3. Repeat step 2 until all the desired tracks are programmed in memory (maximum 20 tracks).
4. To start playback of your order, press the ►|| PLAY/PAUSE button.
Note:
• To clear the program, press the ■ STOP or switch off the power.
LIGHT OPERATION
1. Press the LIGHT button to turn on all the lights.
2. To turn the lights off, press the LIGHT button again.
Note:
• Switch the MODE selector located on the back of the unit to change light mode.
RADIO OPERATION
1. Uncoil the Wire Antenna and extend fully for better reception.
2. Set the MODE SELECTOR know to your desired band (AM or FM).
3. Tune to the desired radio station by using the TUNING knob.
4. To turn the radio off, press the POWER button.
EXTENSION SPEAKER CONNECTION
1. Connect each speaker wire to the speaker terminal on the back cover
2. Switch the external speaker function on by setting the speaker switch at the back of the unit to
ON. The sound from the internal speakers will be cut off.
3. To listen to the sound over the internal speakers again, set the speaker switch at the back to
OFF.
USB / SD CARD READER
1. Set the MODE SELECTOR knob to “CD.USB.SD”.
2. Press the CD/MP3 / USB / SD MODE button repeatedly to switch into USB or SD mode.
3. Insert your USB Flash Drive or SD Card into the slots.
4. The unit will search and play all the MP3 formatted le and repeat all tracks automatically.
5. The playback functions are the same as for CD playback.
IMPORTANT NOTE:
To avoid malfunction on both your devices, make sure the unit is in off mode before insert the USB
FLASH DRIVE / SD CARD!
Notes:
• Because of non-standardized format denition/production of USB Flash Drive or SD Memory
Card, playback quality and performance are not guaranteed.
• Manufacturer is not responsible for the playability of USB Flash Drive or SD Memory Card, due to
recording conditions, such as PC performance, writing software, media ability, etc.
• Manufacturer is not responsible for any loss or damage of data.
• A USB device must always be connected directly to the USB port of this product. The use of a
USB extension cord is not supported by this product. The USB port of this product cannot com-
municate with a computer directly.